top of page

Altair Webinar : Simulation-based Design & Performance Verification of Transfer Chutes – Case study (Part 2)

Thu, 11 Jun

|

Webinar

Registration is Closed
See other events
Altair Webinar : Simulation-based Design & Performance Verification of Transfer Chutes – Case study (Part 2)
Altair Webinar : Simulation-based Design & Performance Verification of Transfer Chutes – Case study (Part 2)

Time & Location

11 Jun 2020, 2:00 pm MYT

Webinar

About the event

This webinar will demonstrate how bulk material flow simulation software can be used to evaluate and verify the design performance of transfer chutes. 

 It will address key engineering design challenges such as:  

- Prevent plugging 

- Reduce spillage and dust generation  

- Identify excessive material velocities  

- Identification of potential build-up regions  

- Ensure appropriate presentation onto equipment and belts  

- Optimize wear protection  

Agenda covers the following: Case study on coal transfer chute.  

- EDEM simulation of original design  

- Identification of potential issues: spillage, blockage  

- Development of a reliable design  

- EDEM simulation of proposed design  

- Overview of the design and operation improvements  

Presenter : Dr Andrew Grima, B. Eng (Mech), PHD, Chief Operating Officer, Bulk Materials Engineering Australia (University of Wollongong)

Share this event

bottom of page